liposuction in atlanta vs Other Liposuction Techniques

Compare traditional liposuction with its 21st century counterpart, SmartLipo.

One way to compare the traditional liposuction procedure with today’s procedure SmartLipo is to look at the key areas where they differ, areas that you as a patient should be aware of.
General or local anesthesia

First and foremost is the most immediate difference, how is the procedure done: under general or local anesthesia?

For the more invasive procedures such as liposuction and breast augmentation a general anesthesia or heavy IV sedation is used. This requires that the patient be unconscious. And be admitted to a hospital or same day surgery center for the procedure.

With liposuction in atlanta, only local tumescent anesthesia is required. For most patients this means a visit to their physician’s office for the procedure. The patient remains awake and alert.

Another major concern for any patient is that of pain. “Will I be in pain, and if so, for how long” is a typical question posed to the physician. This is a completely legitimate question and should be asked.

Patients choosing traditional liposuction surgery done under general anesthesia can expect 3 to 14 days of mild to moderate pain. This discomfort is usually addressed by prescribing pain medication.
For patients selecting Smart Lipo seldom encounter post procedure pain. They enjoy an easy recovery. Most patients are able to return to normal activities immediately or within a few days. All this without the need for potentially dangerous prescribed pain medication.
Recovery Time

A third question is about recovery time. “How long can I expect to be out of commission?”

Here again the traditional liposuction treatment requires a long recovery. 1-2 weeks time off from work. Patients are often unable to return to full activities for several weeks.
With the 21st century technology used in a Smart Lipo procedure you can expect a return to normal activities the same day. Certainly no longer than 2 – 3 days.

A major concern for many patients is that of scarring. If a goal of undergoing a fat removal and body contouring procedure is to look good, especially in a swim suit, then you need to know about scarring.

Traditional liposuction requires an incision ranging anywhere from very small to several inches. And the scarring from this procedure is permanent.
With today’s method incorporated into SmartLipo there are no unsightly scars. In fact, most patients cannot identify any scars 12 months after the procedure.
The Final Outcome


What can you, as a patient, expect as the final outcome to your fat removal procedure? Here again let’s compare the two methods:

Traditional liposuction requires the use of larger instruments. This often leads to a higher risk of contour and skin irregularities.
With Smart Lipo you’ll see smoother results with most patients seeing increased skin retraction and tighter tone.

An all important question is that of cost. How do the two procedures compare in cost?

You can expect a much higher cost with traditional liposuction surgery. This is due to the costs of anesthesia as well as the expenses incurred from either a hospital or same day surgery center.
Here again the cost of the Smart Lipo procedure is usually less than any other method. You don’t have anesthesia or facility charges to pay. You’re in and out the same day.

Finally, there is the matter of risk. While all invasive procedures have a degree of risk it is important for you to know just what those risk factors are. Before doing this type of procedure your physician will review with you what is called an informed consent agreement. In that agreement are the risk factors you may encounter. Here is some of what you’ll read about.

There can be significant complications possible with traditional liposuction. These include anesthesia reactions, organ puncture, infection, blood clots, severe hematomas, and contour irregularities.
Smart Lipo has an extremely low rate of complications as documented in medical literature. No direct deaths have been reported from the use of this procedure.

Skin Tightening Fix with Ultherapy Atlanta

Are you starting to notice loose skin on your neck, jawline, and your brow region? Do you feel you look tired?

Ultherapy is the latest technological procedure that lifts and tightens the skin and provides an alternative to surgery. Ultherapy utilizes focused ultrasound energy targeted at the deeper layers of the skin. It results in improvement in skin elasticity in the brow region, the lower face, and neck. Ultherapy is the only FDA-approved non-surgical device for lifting the brow. There is no downtime after the procedure and you can resume normal activities immediately afterwards. You will notice an immediate tightening and results will continue to improve over three to six months.

Within a tranquil and luxurious environment at Ultherapy Atlanta, your doctor will map out a plan for you so that you can get started on looking your best. Ultherapy is ideal for those not ready for surgery and just starting to notice sagging skin. Visit for a complimentary consultation.

My original area of concern was my jowls, my jaw line. That’s where I noticed the age. Ultherapy uses ultrasound therapy to lift and tighten the skin naturally without using any surgery. No cut and paste involved which I was very happy about. It usually takes an hour and you walk out looking exactly the same and slowly as you wake up every single day you’ll begin to notice a difference and then when three months hits, you’ll be looking really tight and everybody will notice. They’ll acknowledge that you look younger but they won’t be able to pinpoint what it is.

The immediate results that were in my skin were glowing and I could feel my skin was thicker. Because as you age, it becomes thinner and you lose that collagen in your skin. You just felt it feeling thicker. I want to maintain my face for the next 20 years exactly the way it is. Ultherapy can do that.


Reviews for Coolsculpting in Atlanta

I’m contemplating getting Coolsculpting done in Atlanta but I wanted to be absolutely sure. Below, I’ve shared some of the recent testimonials from SlimPlasty but I wanted to share with you guys to see what you think.

I decided to do Coolsculpting Atlanta because I figured it was a better alternative to having surgery done and the recovery process is a lot faster, so I figured why not give it a try. I did my abdomen. I’ve tried diet. I tried exercise. My brother is a personal trainer so I worked out with him. I tried everything and that problem area just never went away. It felt like a vacuum tugging on your skin. You’re never going to expect it. It’s actually a little shocking but it does not hurt. There’s no pain, nothing whatsoever. It was actually very relaxing. During the treatment, I actually took a nap. I fell asleep, you don’t really feel it and they turn off the lights. -Katy

I decided to do Coolsculpting because of my lower abdomen, that is my major problem area and I wanted to try to fix that. I’ve tried working out, eating right, drinking a ton of water, and that problem area was still there. So that’s why I thought about Coolsculpting. It’s actually really cold on your skin so you get that freezing effect. And then it was more of a suction but after five minutes you don’t even feel it.  -Ella

I didn’t really want to do surgery, but after I had my daughter I had the little mommy pooch that I could not get rid of no matter how much I exercised and did crunches. So, I thought that this would be a great alternative. First it was a little uncomfortable, the first initial application. But then, you get numb and you just sit there and you can watch TV and it was perfect. -Sam

Here’s what the doctor had to say:

coolsculpting machine

coolsculpting machine

In our office when we purchased the equipment, I knew it had been a great product but all of the girls in the office wanted to have it done. But when it actually came time to doing it, no one volunteered. So they looked at me and I say sure, and I did it. I work out a lot, I do a lot of biking and it couldn’t get rid of my love handles. What we do is we use a suction and cold temperatures to crystallize and freeze fat away. The fat is dead. It’s gone. Your body naturally eliminates it and it never comes back. It’s only uncomfortable for about ten minutes, and then, I prop you up on pillows, you can get nice and comfy on the chair, and turn the TV on. I tell people about Coolsculpting pain because I did it. Out of a 1 out of 10, I think for the first couple minutes, I might’ve gotten 2 or 3 in the love handles. And I really didn’t find it that uncomfortable. After the first two or three minutes I just sat there. While I was sitting there I did a lot of my texting, looked at my emails, I checked all my emails for the day. So it really wasn’t a major event. The only real discomfort I had was that it feels a little weird because it’s a little numb but no pain. Initially I thought I wasn’t getting anything, but after about a month, I said let’s get a picture and it really is pretty evident on the picture on the before and after that it had worked. And then I just forgot about it and then three months later, after the original procedure, we had pictures taken again and it looks really amazing. There was no muffin top and I noticed my pants were a little looser.

So what do you guys think? Skeptic? Honest?


Cutting Up diamonds

In choosing diamonds for engagement rings, the cut is usually the most important characteristic by women rather than the carat. It, after all, determines style. Color, sometimes, comes next. But for the really discriminating, clarity and carat are the most important characteristics for them.

So, how is cutting done to transform those natural rough diamonds extracted from mines into those gems fit for rings and jewelry?

It is a multi-step process. Diamonds, after all, are extremely hard. Unlike gold necklaces for men, no matter how hard they are, however, they can be roughly split by using a single blow. Diamond cutting, therefore, is a tedious and delicate art that necessitates not just skill, but scientific knowledge, the right tools and the right amount of experience. This is the reason why diamond rings and jewelries are more expensive than those types used for industries.

diamond vs gold chains for menThe aim for diamond cutters preparing diamonds to be made for jewelries is to make the gem shine at its brightest; that is to optimize its lustre. That takes cutting at certain specific angles at the different facets of the stone so that the white light dispersion is optimized. The area and the number of facets of the stone would also determine the weight of the gem. To what type of accessory the gem will be used is also a consideration in the shaping the gem. The use of other gems and their shapes are also placed into consideration during the cutting process. Wedding bands and solitaires are relatively easy to cut, then, as this consideration is no longer an issue.

But, the preliminary analysis of the rough diamond is really the most time-consuming part. In fact, it takes years for one to complete the analysis of unique diamond stones. It is laden with much responsibility as the analysis process needs to address several issues.

Crystal Orientation

One of the factors to analyse before cutting the diamond is its crystal orientation. X-ray diffraction is used during the analyses. Knowing the crystallographic structure would help determine the optimum cutting direction. The stone’s hardness and how easy it is to be cleaved depend on the stone’s crystal orientation.


Rare it is for diamonds not to have any crystal flaws or visible non-diamond inclusions. Upon analysis and inspection, the cutter needs to decide which of those flaws need to be removed during cutting and which should be kept.

Speed and Risk

The degree of care necessary in the cutting needs to be determined. Should speed be a more important consideration, cutting the diamond stone using a pointed tool and a hammer and splitting it with one well-calculated blow would be preferred. Yes, it is quick. But it can be risky, as well.

If precision is more important than speed, a more tedious process of using a diamond saw is a more reliable and preferred method.

The shaping process does not stop with the initial cutting. The cut stone is then subjected to numerous polishing processing. Polishing is relatively more time consuming than mere cutting since it is the removal of the material through gradual erosion. Since it is a well-developed and documented process, however, it can be done by technicians.

It is, then, re-examined for possible flaws, especially if the gem is for those well-coveted diamond rings.